Significant packet loss at lower battery voltage

[Akhil]

We have conducted some form of RF performance test at various battery voltages (3V, 2.5V and 2V). And the results we got shows significant degradation in performance at lower battery voltage. Please review the results we got and let us know what is wrong here.

Test Setup:

A 50mAh coin cell battery was drained at constant 13mA (tx current of NRF) to get the target cell voltage. Our custom nrf51822 was running a program which advertises every 100 ms at 0dB tx gain. Texas Instrument's RFSniffer was used to capture the Broadcast Advertisements. Sniffing was done for 1 minute to capture a theoretical maximum of 600 packets. From this Average RSSI and % Error were calculated. This process was repeated at various distances.

I have attached the results. Please let us know your suggestions about this behaviour.

RF test @ 2V & 2.5V.xlsx,

RF test @ 3V.xlsx

[Øyvind Karlsen]

Hi,

First off I disagree with the method you are using to deliver your test case voltages to the board. The CR2032 coin cell battery will not have the same characteristics when the voltage drops, it is intended for use around 3.3 V, in fact 2 V output from a coin cell is practically breakdown. Instead use a power source with a current limiter feature.

We have never seen results like this internally. The results are also strike me as a bit weird, the RSSI values indicate that you should have no problems picking up packets.

It is likely that something is not working correctly on your board.

• Are you using internal LDO or DCDC for the nRF51822?
• What is the power supply like on your board, are you using any high ripple voltage transformers?
• Have you verified the behavior of your 16 MHz crystal?

You can also submit your layout for review on our closed support portal, MyPage.

Best regards,

Øyvind

[Øyvind Karlsen]

Oh, and in order to use the development kit at 2 V you have to solder SB12 in order to bypass the backwards voltage diode, so that you do not lose voltage level. Then you can use the external voltage pins as before.