I am trying to implement GPS code.

[Gunjan Yadav]

I am trying to implement GPS code in the nrf9160 but I cant find the function nrf_modem_gnss_init(); to initialize GNSS inside the modem in , is it being initialised within nrf_modem_gnss_start() function internally ?   please help on this.

[Hakon]

You should check if the LNA gets properly enabled. Since you are using a regular GPIO pin instead of COEX0, there can potentially be issues.

GNSS gets started and is receiving PVT notifications once a second, so it does not look like a GNSS API issue.

[Gunjan Yadav]

This is an internal GPS setup and has external on-board antenna attached to it. 

I can see voltages around D1(2.489 at cathode ) , D2 (2.673 at cathode ) which further goes to c1(2.48), c2(2.49)  and c3(2.67), c4(2.67) which are sufficient to power up LNA. 

Is there anything else I am missing in the code ?

Also coex is used for coexistence of LTE along with GNSS. Here I am using GNSS mode only in the code. 

 

Hakon 

[Karthik]

GPS_COEX0_Modem_Traces.bin

Hi,

   Captured modem traces with COEX0 Enable

[Tommi Kangas]

Hi Karthik,

For some reason, the modem log stops almost immediately (1 second) after GNSS start. Please try to capture a longer log. Let GNSS run at least for a couple of minutes.

BR,
Tommi

[Gunjan Yadav]

Hello Tommi Kangas 

Could you please share the correct procedure for capturing enhanced GNSS modem traces over RTT on the nRF9160?

I have enabled the RTT modem trace backend and am monitoring RTT channel 1. After entering GNSS functional mode, I enable tracing using:

nrf_modem_at_cmd(rsp, sizeof(rsp), "AT%%XMODEMTRACE=1,5");

However, I only see AT command transaction logs and no GNSS‑specific modem traces.
Please let me know if there are any additional steps or ordering requirements to get the enhanced GNSS traces over RTT.

modem_traces6.bin

Regards,

Gunjan

[Gunjan Yadav]

Hello team Tommi Kangas 

Hakon 

Does nrf9160 support only GPS or we can do all satellite system like use GLONASS GPS galileo etc ?Also in order to enable QZSS do we explicitly need to write some command or is it handled by 

nrf_modem_gnss_start();

api internally ?

FYI Karthik 

[Tommi Kangas]

Hi Gunjan Yadav ,

nRF9160 supports only GPS and QZSS. QZSS is enabled by default and it does not need to be enabled separately.

Enabled signals can be configured using nrf_modem_gnss_signal_mask_set() if needed.

BR,
Tommi