Power Profiler kit ii on nRF54L15

[haan]

Hi, 

 i am asking for the configuration for  power profiler kit ii setup to the nrf54l15. The reason was when i removed the jumper from P6, the external sensors which were connected to the board went off. i thought something was faulty on the sensor board but realised that when i removed the jumper, the PORT 1 VDD:IO drop from 3.3V to 0.4V. So how am i going to measure using the power profiler kit ii with the sensors connected to the board?

With Jumper:                                                                                 Without Jumper:

   

Setup with Jumper:                               Setup without Jumper:

[Ressa]

For source meter mode, where the supply directly comes from PPKII, you need to connect VOUT (from PPKII) to nRF54 pin (on DK), and also GND pin from PPKII to GND on DK. Then in software you choose Source meter and select the desired voltage and then enable output power.