nRF9151 Low Power Mode.

[Medical Device]

I am using the nRF9151 DK, using the Serial LTE Modem firmware from the nRF Connect quick start.

I am planning to use nRF9151 as a serial modem, and connect it to my Host MCU using UART.

I am using the Power Profile II to measure the current of VDD_nRF.

Questions:

1. Is this the product code that I should be using for my final product?
2. Power save mode:
   1. I set the modem LPM. The average current is about 500uA in LPM. Why is it still so high? What is nRF9151 drawing current for? Is it because nRF9151 UART is still enabled?
   2. I press button 1 on the DK, the average current went down to 3uA.
   3. I press button 1 again, it seems to wake the nRF9151 up, with average current about 500uA again, but I lost all network configurations.
   4. Questions:
      1. What does button 1 do exactly? Any documents that describe exactly what it does?
      2. What is the proper way to go into deep power save mode, assuming I am using this Serial LTE Modem firmware in my final product?
      3. Is there a even lower power mode that the button 1 method? i.e. average current < 1uA maybe?
3. There are some instances, when I leave the DK alone for maybe 10 mins, then I tried to send a AT command, the DK is not responsive in the sense it did not send back "OK" or network messages. However, my AT command was executed (based on the current profile of the Power Profiler II). Is this a know issue? Below image shows this error. In the image, bottom right, a few AT commands are sent but there were not response received.

[Achim Kraus]

Medical Device said:

average current is about 500uA

This is usually caused by the UART receiver. To reduce it down to 3-6µA you need to suspend the UART and wake it up, when you need it again. That wake up is the frequently done/implemented by some GPIO. There are also some implementations, which using the RX for that, but it depends on your requirements.   

Medical Device said:

I will just program whatever production-certified modem firmware and application firmware without any recompilation,

The term "certified" may mean a lot of different things. Let me recommend, that you first clarify, what it should mean. Otherwise you will risk a very big disappointment in the end ;-).

[Medical Device]

Hi Achim.

Maybe 'certified' is not the right word. What I meant is, I want to just use a compiled version of the serial modem code that Nordic recommend its customers to use, even for final production. Assuming we can adapt to the GPIOs and UART pins defined in the code, it will save us the trouble of modifying and compiling the code ourselves.