Control Segger flasher ARM Target Power supply using nRFutil.

[A Noniem]

Is it possible to enable the Segger Flasher ARM Targer power supply using nRFutil?

We are now using a Segger Relay adapter, but this needs the Flasher's ARM  target supply rail (VTSUPPLY, pin 19) to be enabled.

Normally this can be controlled within J-Flash under "Options->Project Settings->Production-> Target Power Supply", by setting Power source to VTGT.

[Priyanka]

Hi,

I don't think this is possible, since the nRFutil's device command can program/reset/recover targets (Nordic devices) via J-Link or MCUboot, but only at the level of programming operations and device management, and not low-level probe features like target power control.

I will nevertheless check this once again and get back to you.

-Priyanka

[Priyanka]

Hi,

As mentioned, it is not possible to do this currently and we do not support production line use-cases in nrfutil-device.

-Priyanka