Application is not running in SDK V8 for mesh network

[Manjunath]

Hi all,

1. I am developing a mesh network and i am using pca10001 EK V2.2.0 for nrf51822. Some one suggested this link: github.com/.../sdk-8-support I did what they suggested, first i used soft device s110 v8 and ble_Gateway application, i can able to program without any errors. But application is not at all running, i make sure in debug mode.

Can any one please tell me why it is like this?

2. Then i tried with soft device s130 and unable to load application hex file, it showing erase failed. So i changed rom to: start=0x14000 size: 0x2B000 and RAM : start=0x20005000 size=0x5000, then also it is giving same error.

Can any one please tell me why it is like this?

Regards Manjunath N N

[Trond Einar Snekvik]

Hi, Your application should start at the end of the Softdevice you're running with.

With S110v8, your application should start at 0x18000 in ROM (size=0x28000), and 0x20002000 in RAM (size=0x6000).

With S130, your application should start at 0x20000 in ROM (size=0x20000), and 0x20002800 in RAM (size=0x5800).

Try erasing the entire chip, program whichever softdevice you prefer (I recommend S110, as this is the main target for the framework), set the correct start-addresses and sizes in Keil. Compile and flash. You should see your device entering the main-function.

[bjorn-spockeli]

Yes, QFAA G0 is IC revision 2 and is not compatible with S110 v8.0.0 or S130 v1.0, please see this page on our Infocenter.