This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

rigado BMD-300 with nRF52 DK

image description HI, Can anybody give me the connections to a BMD-300 with nRF52DK and the steps to program a BMD-300 from scratch? Which document provides the information, if there is any?

thanks, Vishnu

Top Replies

Dt over 8 years ago +1

The BMD-300 has read-back protection enabled from factory. Use this utility to do a full chip erase. After that you'll be able to program it. rigado.zendesk.com/.../226811567-BMD-300-Erase-and-Reco…
Vishnu Pradeep over 8 years ago +1

Hi Devs, The problem was with the soldering of custom board. I followed the connection which Wojtek has mentioned. It is working now. Thanks for your support guys. regards, vishnu

Parents

0 Petter Myhre over 8 years ago

Isn't this explained in the BMD-300 data sheet? And the nRF52 DK Debug output section?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Petter Myhre over 8 years ago

Isn't this explained in the BMD-300 data sheet? And the nRF52 DK Debug output section?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data