rigado BMD-300 with nRF52 DK

[Vishnu Pradeep]

HI, Can anybody give me the connections to a BMD-300 with nRF52DK and the steps to program a BMD-300 from scratch? Which document provides the information, if there is any?

thanks, Vishnu

[Dt]

The BMD-300 has read-back protection enabled from factory. Use this utility to do a full chip erase. After that you'll be able to program it.

rigado.zendesk.com/.../226811567-BMD-300-Erase-and-Recovery

[Wojtek]

I tested that with my custom board, not the BMD, but i think that should be the same. I also dont have special cable, I just soldered 3 wires to the (GND, SWDIO, SWCLK) pads of the header. And remember about powering board you are willing to program.