• State Not Answered
  • Replies 20 replies
  • Subscribers 73 subscribers
  • Views 10318 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 117107
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

rigado BMD-300 with nRF52 DK

Vishnu Pradeep

image descriptionHI, Can anybody give me the connections to a BMD-300 with nRF52DK and the steps to program a BMD-300 from scratch? Which document provides the information, if there is any?

thanks, Vishnu

Parents
  • 0

    Yes, i am using only 3 wires and it works ok. I don't know how exactly it detects, but when i power up external board and it is connected as I said, it is programmed by DK. if it is not powered - internal MCU of DK is being programmed. So detection works ok. P19 pinout is standard 10-pin SWD connector - just note where pin 1is! You can find schematics on nordic website

    I don't know about powering. I am powering my board from power supply. probably depends of current consumption

Reply
  • 0

    Yes, i am using only 3 wires and it works ok. I don't know how exactly it detects, but when i power up external board and it is connected as I said, it is programmed by DK. if it is not powered - internal MCU of DK is being programmed. So detection works ok. P19 pinout is standard 10-pin SWD connector - just note where pin 1is! You can find schematics on nordic website

    I don't know about powering. I am powering my board from power supply. probably depends of current consumption

Children
No Data
Related
Terms of service