This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

[title:nrfgo studio]

When i used board 0 extension board to program nRF24LE1 QFN24 OTP/Flash. it notification of error "An error occured when programming the infopage of board 0". What's that meaning ?

Top Replies

Hung Bui over 8 years ago +1

You mean if you check "Block readback" it flashed with no problem ? Have you verify that the firmware worked properly after that? Were you able to re-flash the chip, for example modifying the firmware…

Parents

0 Hung Bui over 8 years ago

Could you click on Advanced Setting and make sure you don't check "Enable hardware debugging" and "Block readback of main memory".

Also please test with simple application such as blinking LED. Note that you are using OTP chip, so it could be wise to test first with normal chip.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Hung Bui over 8 years ago

Could you click on Advanced Setting and make sure you don't check "Enable hardware debugging" and "Block readback of main memory".

Also please test with simple application such as blinking LED. Note that you are using OTP chip, so it could be wise to test first with normal chip.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data