nrf51422 low voltage mode programming problem

[TT]

Hi, I've migrate from 3V to 1.8v power supply. before the migration, using 3V power supply, DEC2 connected to 47nF directly to GND. after the migration, using1.8V power supply, DEC2 is now connected to 1.8V with 47nF.

After the migration, J-link cannot find the device, although that I've measured 1.8V on DEC2 pin.

what want wrong? do I missing something?

[Håkon Alseth]

Which JLink are you using?

Note that the SEGGER JLink lite CortexM only support 3.3V. To program a device running on a different voltage than this, you should look at this one: www.segger.com/jlink_base.html

BR Håkon

[Håkon Alseth]

It will not program the nRF. You'll need 3.3V (+/- 10%) for it to work properly.