PCA10040 jlink disconnected while in use

[hslee]

We were doing various tests using PCA10040. Then suddenly I can not connect to the PCA10040 board. In the boot loader mode of PCA10040 board, connection is made. What is the problem? How is it possible to recover to its original state?

[hslee]

ok.. in bootloader mode. JLink firmware reload...

[MartinBL]

Ok. Sounds very strange. There is actually an erase pin on the Segger chip which, if shorted to VDD, will erase the Segger firmware. However, in our experience this will brick the kit altogether. Is is possible that something has somehow been shorted? Otherwise there must be something in the programming algorithms or drivers.

We will continue to investigate. Thanks for you input.