Hi
I'm using nrf51822 & PCB antenna due to size constraint I changed antenna direction (edit library file) so that it will fit within size. Also, components placement slightly different as recommended.
Please review my design
Here are top & bottom layer
edit: I'm attaching updated layout
There are several issues with this layout.
The feed to the antenna is not characterized, nor is the connection for the match/lumped element balun. These all need to be characterized paths.
Your RF traces seem to run over logic traces. This is not good practice and further illustrates how these are not characterized traces.
Your crystal seems too large. The standard crystal Nordic likes to spec is only 2x1.6mm. Looks like you are causing layout issues just because of the large crystal. In addition most of the chip stuff looks like 0603 whereas you would save a lot of board space by placing 0402 or 0201.
You would simplify the RF routing by rotating the nRF 90 CCW. Though a bigger problem is the ground plane for the inverted F meander hybrid does not look correct. Normally this type of antenna sits at the edge of the ground plane and not in a corner.
I would suggest you consider the 52832 over the 51822. The 52832 has a single ended RF output that would simplify your layout a bit.
Take a look at this layout. This person eventually ended up with a decent layout for 51822 using chip balun and meander antenna:
Here is the blog entry for it: devzone.nordicsemi.com/.../
