This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

PCA10000 Tx

Hi,

I referred to the sample code "led_radio_example" and I think I might miss some thing so the program does not work.

The sample code indicates to use a terminal program on PC to connect to the PCA10000. I have tried "Putty" but there is no response (baud rate 38400, 8 data bits and 1 stop bit). Is there any other terminal program I can use? Or any setting in Putty I might miss?

thanks for help Elca

Parents
  • In the EK_User_Guide, Page 24, the Development Dongle v2.0 UART lines are connected to pins P0.08 to P0.11 as shown in Table 5. The actual problem is the pins changed.

Reply
  • In the EK_User_Guide, Page 24, the Development Dongle v2.0 UART lines are connected to pins P0.08 to P0.11 as shown in Table 5. The actual problem is the pins changed.

Children
No Data