This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nRF52823 HFXO DC specificaiton

Hiya,

Regarding voltage amplitude peak to peak for external high-swing clock HFXO 32MHz, what's supply rails?I don't find out this specification defined in datasheet PS_V1.2.

Thanks Kenji

Parents
  • Hello JGP_Kenji

    Unfortunately the high frequency clock (HFCLK) of the nRF52 series does not support use of an external clock source. The only valid sources for HFCLK are the internal oscillator, or the 64MHz crystal oscillator. Do note that the crystal oscillator must be running for the RADIO and NFC modules to work.

    EDIT:

    The following comment was supplied by our designers

    Based on simulations the peak-to-peak oscillation amplitude on XC1 and XC2 can range from appx. 0.3V to appx. 1.1V, depending on crystal selection, load capacitors, process variation, operating temperature and supply voltage. The amplitude is usually slightly bigger on XC2 than on XC1. The DC offset is typically around 0.5V. When doing voltage measurements on XC1 and/or XC2 it's important to use a low-capacitance active probe. A regular passive probe will add too much load capacitance. The probe should also have an input resistance of at least 10Mohm.

    In order to verify that the load capacitors are optimal, it's best to measure TX carrier frequency.

    Best regards

    Jørn Frøysa

  • Hi Jorn,

    I'd like to know the specification for HFXO 32MHz likes Vamp_in_xo_low defined in datasheet for LFXO 32.768KHz

    Thanks Kenji

Reply Children
No Data
Related