This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

External programming of nrf51/52 using nrf51/52 dk's

Is there any documentation as to how to connect a nrf52 chip (as found on the nRF52832 BT Module with Header Pins (www.analoglamb.com/.../) or the nrf51 on the Adafruit bleFriend (www.adafruit.com/.../2479).

I did see that there are two connectors on the DK's, P19 and P20. P20 has pins marked on the connector. I cannot find pinout for P19.

The analoglamp.com has two connectors, both 2x9, which bring out the nrf52832 pins. On one of these I see the pins SCLK and SDO which I think are SWDCLK and SWDIO.

The adafruit has pins labeled swc, swd, 3volt, and ground. I think the swc and swd correspond to the swdclk and swdio pins on the nrf52832. I see that the P20 has pins VDD (I think this is input), swdclk, swdio, gnd detect and VTG (I don't know what this pin does ??).

I found this diagram. Is it correct?? nrf dk external programming.jpg

thanks for the help,

Richard Ferraro

thanks, Richard Ferraro

Related