error in executing panid command

[sam]

hi i did the setup according to border router setup guide on Nordic info center. all run fine but when i tried to run command ""panid 0xabcd" it saying not found

[Ole Saether]

"panid" is a command in the Thread CLI Example used to test the border router. Check "Thread CLI Example" in the Thread documentation: nRF5 SDK for Thread v0.11.0

[sam]

ok .consider i have flashed thread cli example on one nrf52840 dk .where should i connect that nrf52840 board? (to rpi using usb?) and thn execute the command