• State Not Answered
  • Replies 1 reply
  • Subscribers 73 subscribers
  • Views 796 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 128783
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nrf52 dk debug probleme

AMER

hi i am using nrf52 dk wiht IAR embedded workbench IDE ARM 8.20.1 i want to disable the attach to running target from my device HZX-52832-S01A. which bit i have to turn off to disable the attach to a running target?

thank you,

Amer

Parents
  • 0

    Hi Amer, Could you clarify, do you want to debug and flash the module HZX-52832-S01A instead of flashing the nRF52DK , correct ?

    If you connect SWD interface on the HZX-52832-S01A to either the debug out port P19 or the Shield port P20. The programmer on the DK will automatic redirect the link to the module instead of the nRF52 on board. Make sure you connect the VTG (target VDD) pin so the programmer can detect the port.

Reply
  • 0

    Hi Amer, Could you clarify, do you want to debug and flash the module HZX-52832-S01A instead of flashing the nRF52DK , correct ?

    If you connect SWD interface on the HZX-52832-S01A to either the debug out port P19 or the Shield port P20. The programmer on the DK will automatic redirect the link to the module instead of the nRF52 on board. Make sure you connect the VTG (target VDD) pin so the programmer can detect the port.

Children
No Data
Related
Terms of service