This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

52_DK firmware load with PPK attached

I tried every configuration I can think of to reload firmware on the DK with JLINK drive when PPK is piggybacked. The only way I can get the firmware to load on the DK is to remove the PPK board, jumper the power leads and load the firmware. Then I reconnect the PPK and launch the software.

I am sure I am doing something wrong as this cannot be the planned way to use the PPK. Can I get some advice? Should I use a different loader?

Thanks, Mark

Related