Hello,
I have an issue with a nRF51822 TWI. I am using the "TWI sensor example application" as a base code.
The TWI module seems to powered, enabled and ready to communicate (see figure below)
The PIN set is also correct and the address as well (7 bit address). I also created another project to check my IO using the GPIO module.
On the other side of the bus stands a ADS1115.
Unfortunately, I can not get any signal on SCL and SDA (I am using logic analyser to monitor the bus)
And I can not get any ACK from the ADS1115.
My module instantiation is also correct, no SPI using the same address as the TWI module (0x40003000).
I already had a look on the forum but no answers help me to solve the problem.
Does anyone has an idea to help me, please ?
Best regards
