Hi, I'm trying to flash the S110 onto my nrf51822 SoC, but nRFgo gives me the following error. (Also, hitting recover just gives me an error: "an error condition was detected in the JLinkARM DLL"). I am using a standalone J-Link plus debugger with only the SWD pins connected to the SoC. EDIT: This is a brand new chip. This is the first time I am attempting to connect to it.

99% chance, the line is not well connected. check the soldering.

This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

"No device detected" in nRFgo studio (can't flash S110)

Hi, I'm trying to flash the S110 onto my nrf51822 SoC, but nRFgo gives me the following error. (Also, hitting recover just gives me an error: "an error condition was detected in the JLinkARM DLL"). image description

I am using a standalone J-Link plus debugger with only the SWD pins connected to the SoC. image description

EDIT: This is a brand new chip. This is the first time I am attempting to connect to it.

Top Replies

Parents

0 nan over 10 years ago

99% chance, the line is not well connected.

check the soldering.
Cancel
Vote Up +1 Vote Down

Cancel

Reply

0 nan over 10 years ago

99% chance, the line is not well connected.

check the soldering.
Cancel
Vote Up +1 Vote Down

Cancel

Children

0 hassan789 over 10 years ago in reply to nan

hmmm, i see... ill ohm it out today
Cancel
Vote Up 0 Vote Down

Cancel
0 hassan789 over 8 years ago in reply to nan

confirmed it was a bad connection!! solved
Cancel
Vote Up 0 Vote Down

Cancel