Hi everybody,
I just received the nRF51822 EK and as I was starting to set it up I ran into this. It took me a while to figure it out but when trying lo load the blinky project a prompt saying cannot load flash appeared and then it complained about the device support.
After a while I figured out that the problem was the software pack, for some reason it does not appear on the target device selection and when I open the pack installer and try to add it as a zip gives me an error. Note that this error prompts anyway when I open it since I checked the pack folder and it is already there. See the screenshot below:
At this point I really dont know what to do, I thought it might be version 5.XX that does not recognize the package so I installed 4.74 and still the same issue.
I have been with this for 8 hours now, any ideas?
Thanks in advance,
Gabriel.