unable to download larger bootloader

[Allen]

Hello,

Is there any DFU package that can be created that would enable downloading a larger bootloader? In this case, we have the non-debug bootloader loaded and want to switch to the debug version of the bootloader via a DFU download. These are "sealed" units.

[Bjørn Kvaale]

Can you see your device in Windows File Explorer as a JLINK external disk after you run your eraseall script? What happens when you type nrfjrpog -i in a windows command window? Can you see the Segger ID of your device? I am slightly unsure what exactly happens when you press nrf5x Programming because I am not able to click it myself. But when I click the Segger ID under "nrf52 development boards", I am  sure the device flash is read, as you can see the different regions (application, softdevice, bootloader) in the graphic in the middle. Something similar like this can be done by using nrfjprog commands.

[Allen]

You must be using a different version of "NRFgo Studio". I am using version 1.21.2.10.

Yes, the JLink ID is returned when you run "nrfjproj -i"

Attached is a file which contains all the commands executed to erase, reprogram and hopefully bring the process back to life. The processor does not boot after the reload. However going into "NRFgo Studio" as previously described does cause the processor to boot and run the application. The application must be doing something more than just reading the flash.

Fullscreen download_notes.txt Download

nrfjprog.exe --family NRF52 --eraseall
nrfjprog.exe --family NRF52 --verify --program s132_nrf52_5.0.0_softdevice.hex
nrfjprog.exe --family NRF52 --verify --program bootloader-debugoption.hex
nrfjprog.exe --family NRF52 --verify --program app_settings.hex
nrfjprog.exe --family NRF52 --reset
nrfjprog.exe --family NRF52 --verify --program nrf52832_xxaa.hex
nrfjprog.exe --family NRF52 --reset

Ran these on the command line
  545  nrfjprog.exe --family NRF52 --readuicr uicr.bin
  546  nrfjprog.exe --family NRF52 --readcode code.bin
  547  nrfjprog.exe --family NRF52 --reset
  548  nrfjprog.exe --family NRF52 --run
  549  nrfjprog.exe --family NRF52 --readregs
  550  nrfjprog.exe --family NRF52 --readram ram.bin
  551  nrfjprog.exe --family NRF52 --reset

[Turbo J]

I am missing a `nrfjprog.exe --family NRF52 --run` at the end of the sequence. Looks like you just kept the MCU in reset.

[Bjørn Kvaale]

ajcDid you try running the command that Turbo J mentioned in the comment?

[Allen]

Yes, the run command did not fix the problem. Looking at my previous post, it looks like I had tried that.

[Allen]

The theory about the UICR changing when entering NRFgo is incorrect. There is no difference. The only solution (kludge) that I have found is to assert reset about 4 times after the programming is completed.