RTT Control Block location for Segger SystemView

Is it possible to use the Segger SystemView software with the NRF52832? When attempting to use SystemView, I get an error "RTT Control Block not found". It's possible to enter an address or range of addresses in RAM, but I'm unable to find where this is defined. Attempting auto detection of the RTT control block or entering a range covering all of RAM does not work as well.

I've seen issues on devzone in the past attempting to use this software, with responses about a lack of support in SoftDevice. My application does not use any SoftDevice or RTOS.

Parents
No Data
Reply Children
No Data