Uart and NRF_Logging are printing with noise

[Kautham]

I am using Hackable kit which is a custom nrf52832 board with Bumpy a low cost Black Magic Probe alternative to program since i don't have a J-Link device. I have tried many examples but i cannot get the UART or NRF_Logs to print correctly in the Putty Console. It always prints gibberish (noisy). For this example i ran the example/peripherals/uart from the SDK 15 example with some following simple modifications 

while (true)
    {
          printf("\r\nExit!\r\n");
          nrf_delay_ms(500);
//        uint8_t cr;
//        while (app_uart_get(&cr) != NRF_SUCCESS);
//        while (app_uart_put(cr) != NRF_SUCCESS);
//
//        if (cr == 'q' || cr == 'Q')
//        {
//            printf(" \r\nExit!\r\n");
//
//            while (true)
//            {
//                // Do nothing.
//            }
//        }
    }

As you can see i just print the word "Exit" with 500ms delay through UART. What i get in Putty after running this code is 

The following is my Putty settings 

i have also tries with different flow control options. But always the gibberish noise is present. 

Can someone tell me what's wrong or where is the problem?

[Martin Lesund]

Hi Krishna,

Do you twist the UART Rx and Tx cables? 

if not, this can cause a lot of noise and could also be the reason why you are seeing this "gibberish" noise.

(common pitfalls article)

[Kautham]

Thanks Martin for your time. But i found out the problem it was a hardware PIN failure. Seems like a manufacturing defect. I reconfigured the UART Tx and Rx ports to other working pins and now i get the clean logs. thanks.