Cycling Speed and Cadence sensor central configuration using nRF52832

[Santosh Krishnan]

i am working on the Cycling Speed and Cadence sensor central configuration using nRF52832 DK in Segger Embedded Studio. I used the RSCS central example of nrf_sdk_v15.0 and have made changes according to my requirement for single sensor and it is working fine i.e i am able to get the correct data. Then i wanted to connect nearly 8 such CSCS beacons so i made small changes in my code accordingly using Multilink central example as reference. I have adjusted the RAM and memory allocation also.  My main doubt is once i run the program it gets connected to a single device and it starts reading the data. How am supposed to make it connect and read the next sensors simultaneously ? I need to store the 8 data in an array after connecting all the beacons. I have attached the RTT log for your reference. What am i supposed to do now ? How can i read all the data parallely ? 

[Santosh Krishnan]

Please find the RTT logs of changes i made single cycle and multiple cycles for your reference. 

Kindly help me.

Thank you 

[Edvin]

Hello,

Have you tried to connect to several devices at once? It says that it is scanning for more devices after that you connected with the first one. As long as it enables notification on all of the sensors that it connects to, it should get an event whenever the devices pushes some new data to the device.

 

What happens if you try to connect another peripheral to your central?

 

Best regards,

Edvin

[Santosh Krishnan]

Hi Sir,

Thanks for your reply. 

Right now i tried for 2 sensors only. I tried to read 2 advertisement reports and have put two cscs handlers for collecting 2 sensor's data. Please check the attached RTT logs of my application. I am getting this output only. I tried connecting with different peripheral names. 

I dont know why the discovery is part is repeating 8 time when i tried connecting with a single sensor. It not giving any outputs too when i tried. 

Kindly help me sir,

Thanks and Regards

Santosh Krishnan R 

[Edvin]

Hello,

Exactly why the discovery part is showing 8 times, I am not quite sure either. I have seen it before in the multilink example, so I think there is a small bug there. However,  I have not seen it causing any problems before. We can look into it eventually. But the "Fatal error" is something that we can't ignore for now.

Can you please try to define "DEBUG" in your preprocessor defines? 

A "Fatal error" typically comes from an APP_ERROR_CHECK(err_code); with an err_code != NRF_SUCCESS (=0).

If you define "DEBUG" in your preprocessor defines, it should print some more info in the log, on where in the code the APP_ERROR_CHECK(err_code); that triggered the fatal error is, and what err_code it received. This way we can see what function that returned err_code != NRF_SUCCESS.

 

Please let me know if you find out what function call it was, and what the err_code that is returned is.

 

Best regards,

Edvin

[Santosh Krishnan]

Hi Sir,

I tried as you said to debug and i am getting the following issues. When i tried to connect my 1st sensor its gets connected and the repetition of discovery occurs and after i wake the second sensor it gives the following error in line 780 which is " APP_ERROR_CHECK(ret) " in the whitelist_load function and hex code: 0x0002E00B and stops. When i restart the debugging its scan for and once name matches it stops again by giving the following error in line 787 which is "APP_ERROR_CHECK(ret)" in the whitelist_load function. I have attached the RTT logs and error code for your reference. I have put the peripheral names in an array and have called in the adv_report. 

Kindly help. 

Thanks and Regards,

Santosh Krishnan R