Can not connect Android 8 mobile phones, such as HUAWEI Nova 3

[yangshuanghua]

Can not connect Android 8 mobile phones, such as HUAWEI Nova 3

Nodic equipment is not even found.

We cannot connect with official UART routines.（ble_app_uart）。The phone was not able to found it either.

Do we need to make some special settings when initializing the protocol stack? Or other initialization settings。

the SDK is   13.0

Has anyone ever encountered such a situation?

[Sigurd]

Hi,

Are you using the nRF Connect app? I would recommend using that. See this link.

[yangshuanghua]

I tested it with NRF connect.

If you have a development board, you can find a Android 8 mobile phone,such as HUAWEI NOVA 3 OR honor play.

Try this situation.

Occasionally, Bluetooth devices can be found, but the probability is very little.

SDK: 13.0.0

Demo: ble_app_uart

[Sigurd]

yangshuanghua said:

Is it our  board‘s problem? But it works fine with other phones .

I think it's most likely an issue with the huawei phone.

yangshuanghua said:

my iphone can find the  " Nodic_UART"

So then it's only connecting that’s the issue.

1) Do you get any error-code in the nRF Connect app log when you try to connect?

(To show the log: Swipe from left to right, or click on the 3-dots in the upper right corner and click "show log")

yangshuanghua said:

By the way ,where can I buy A  PCA10040 board ..A real PCA10040  board.

I recommend buying it from one of our distributors. See this list.

With a nRF52-DK we can also use the nRF Sniffer to see what's going on-air. This could help us find the root cause of the issue, by inspecting the content and timing of the on-air packets.

[yangshuanghua]

I have tested PCA10040. He can connect with the HUAWEI phone 。

Maybe it's our board problem.

There may be frequency offset.

Our crystal oscillator and capacitor may not match.

[Sigurd]

Yes, this indicates that there is a problem with the custom board. I recommend taking a look at the tutorial "General PCB design guidelines for nRF52 series", found here. Please make sure that your load capacitors for the 32 MHz crystal follows the formula in the chapter “Crystal and load capacitors”.

[yangshuanghua]

I'll try it ,thank you ！

[david]

hi yangshuanghua

    did you find the problem with your custom board? i have the same problem with our custom board, would you please give me some advise?