nRF24LE Info Page

[Gary]

I have many nRF24LE1E chips that have a corrupted Info Page. I use the Dataman-48Pro2 programmer. I have read and saved the Info Page from a working chip but have not been able to restore the Info Page on a non-working chip. Can you recommend a method or a programming device that is capable of writing to the Info Page? I have received confirmation from Dataman that their programmer can only read the Info Page but not write to it. The corrupted Info Page has occurred while our developers have inadvertently written to the Info Page area. We would like to be able to restore these corrupted chips.

Thank you,

Gary 

[ovrebekk]

Hi Gary

If you have a working development environment for the nRF24LE1, based on the nRFgo Starter kit, then it is possible to restore the info page to a default state. 

I wrote a document describing this procedure many years ago, and you will find it attached:
corrupted infopage.doc

Best regards
Torbjørn

[Gary]

Thank you for the reply. I did read the Info Page before starting to work on programming the chip. I would like to restore the Info Page to the values that I saved rather than default values. Does the nRFgo allow that? I am using a Dataman-48Pro2 programmer and it does not write to the Info Page. The Dataman can only read the Info Page which I did and I saved it to a file. I am trying to restore the Info Page to the values that I saved. I can purchase a nRFgo if that will solve the problem. Can the nRFgo Starter Kit restore the Info Page from a file that contains the saved Info Page?

[Gary]

Thank you. Our document department had a question. If there is a future software update for the nRFgo Studio will the Info Page change be in it or will we have to request a patch for the new version?

[ovrebekk]

Hi Gary

It is unlikely there will be more updates to nRFgo Studio, but if there is one the developer would expect this feature to be included. 

We can't guarantee it 100% though, so if an updated version comes out without it I suggest you get in touch with us again. 

Best regards
Torbjørn

[Gary]

Hello, on the nRFgo Starter Kit I'm trying to build an ISP cable to program the nRF51822 which uses a single wire DIO line. The ISP pinout in the manual only shows a separate MOSI & MISO. Can the nRFgo Starter Kit program a nRF51822 with a single DIO line? If so, what is the pinout on the ISP port for the nRF51822?

Sincerely,

Gary

[Gary]

I installed the software for the nRFgo nRF6700 started kit. But it looks like the software is for the nRF8001 & nRF8002. I don't see anything about the nRF6700. Did I install the wrong software? If so, can you give me a link to the correct software?

Thank you,

Gary

[ovrebekk]

Hi 

You can't use the nRFgo Starter kit to program any of the nRF5x family of devices. 

With the move from the nRF24L series to the nRF5x series we moved from an SPI based programming interface to a 2-wire SWD interface, and the nRFgo Starter kit doesn't support this interface. 

I would suggest you buy an nRF51DK to do development on the nRF51 series. The DK comes with a debug out port that allow you to program external boards (you need to buy the 10-pin J-Link connector separately). 

The nRF6700 is referred to as a Motherboard in nRFgo Studio. If you have your board connected it should show up under Motherboards in the Device Manager window on the left side. 

Best regards
Torbjørn