nRF52832 current consumption issues

[YCH]

Dear all,

Working with nRF52832 (currently without SoftDevice), and there some issues regarding the project current consumption that we need to understand:

1) In the PS (v1.1) documentation, in section 7.2.1 "CPU performance", there is a current definition

of IDDFLASHDCDC/MHz that can be as low as 58uA/MHz.

The current consumption in our project was dropped from 5.5mA to 3.5mA, but still, it's far from the expected current of 0.928mA (=58nA * 16), what else should be done/configured to achieve this goal?

2) In our low power SAADC module, we set tACQ (Acquisition time) to 40usec and tCONV (Conversion time) to 2usec, once again, in the PS (v1.1) documentation, the IADC,CONV current definition is 700uA, we want to know that it refers to the time frame of 42usec and the current will be in idle mode otherwise, and if this isn't the case is there a way to configure it to that time frame only? 

3) In the low power SAADC module, we use an easyDMA, and the current consumption is about 1.5mA, is there a way to reduce that?

In other words, to make sure that the easyDMA is in idle state during the time between samples?

Thanks in advance,

Amir.

[Nguyen Hoan Hoang]

First thing before you do any current consumption test is to put the mcu to sleep without doing or activating anything else.  This means in the main() just do a while (1) { __WFE(); }, nothing else.  Compile in release mode.  Then measure how much current, (no debugger or jtag connected).  The current should be less than 10uA.  Anything higher than that means you have hardware leaks in your design.  Then you active one by all your io to find out where which i/o leaks more.   

This example here https://github.com/I-SYST/EHAL/blob/master/ARM/Nordic/exemples/TPHSensorTag.cpp reads temperature, humidity, pressure and gas from the BME680, ADC to read battery level and advertises them over BLE.  The average current is around 15uA.