nRF52832 current consumption issues

[YCH]

Dear all,

Working with nRF52832 (currently without SoftDevice), and there some issues regarding the project current consumption that we need to understand:

1) In the PS (v1.1) documentation, in section 7.2.1 "CPU performance", there is a current definition

of IDDFLASHDCDC/MHz that can be as low as 58uA/MHz.

The current consumption in our project was dropped from 5.5mA to 3.5mA, but still, it's far from the expected current of 0.928mA (=58nA * 16), what else should be done/configured to achieve this goal?

2) In our low power SAADC module, we set tACQ (Acquisition time) to 40usec and tCONV (Conversion time) to 2usec, once again, in the PS (v1.1) documentation, the IADC,CONV current definition is 700uA, we want to know that it refers to the time frame of 42usec and the current will be in idle mode otherwise, and if this isn't the case is there a way to configure it to that time frame only? 

3) In the low power SAADC module, we use an easyDMA, and the current consumption is about 1.5mA, is there a way to reduce that?

In other words, to make sure that the easyDMA is in idle state during the time between samples?

Thanks in advance,

Amir.

[Einar Thorsrud]

Hi,

Nguyen Hoan Hoang 's answer is important. I have some additional comments (linked to your numbered questions):

1) The CPU frequency of the nRF52832 is always 64 MHz, so your calculation is not correct. It is essentially the same number as IDDFLASHCACHEDCDC (3.7 mA).

2) The current consumption numbers given for the SAADC (and other peripheral) only reflect the current consumption of the peripheral itself, not any resources it depends on. So the IADC,CONV number of 700 μA does not include the current consumption of the clocks, regulator or DMA logic. Therefore, the total current consumption is significantly higher. The system will consume significant amounts of power between sampling as well, as these resources are constantly enabled while the SAADC peripheral is enabled.

3) The best way to reduce the SAADC current consumption is to minimum between sampling is to disable the SAADC peripheral, provided that you do not need to use it frequently or have a very accurate sampling rate.