• State Verified Answer
  • Replies 6 replies
  • Subscribers 63 subscribers
  • Views 5365 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 100044
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

hex file for MCP dongle

Bret Foreman

I can't seem to find the hex file to download into the PCA10000 in order to use it with the Master Control Panel. Where is this documented in the dev-kit documentation?

Parents
  • 0

    execution me, i miss the message that flash program from master control panel itself. i program the the flash from nrfgo studio ,and can't work . how can i to reconfigure it?

    it always show me:

    Running application C:/TEMP/nrf51Studio/nrfjprog.exe --snr 480101280 --program C:/Program Files/Nordic Semiconductor/Master Control Panel/3.4.0.8098/firmware/pca10000/MEFW_nRF51822_0.8.0_firmware.hex --reset ERROR: Segment was attempting to write in protected area! aborting..

  • 0 in reply to steven

    This would have been a lot better as a separate question, but the answer is most likely that you have programmed the softdevice before trying to flash the Master Emulator firmware. That should not be done, since the Master Emulator firmware doesn't use the softdevice.

    If this does not make it work, I'd be happy if you could post it as a separate question, since it has nothing to do with the original question here.

Reply
  • 0 in reply to steven

    This would have been a lot better as a separate question, but the answer is most likely that you have programmed the softdevice before trying to flash the Master Emulator firmware. That should not be done, since the Master Emulator firmware doesn't use the softdevice.

    If this does not make it work, I'd be happy if you could post it as a separate question, since it has nothing to do with the original question here.

Children
No Data
Related