• State Verified Answer
  • Locked Locked
  • Replies 3 replies
  • Subscribers 67 subscribers
  • Views 2408 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 104528
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

nRF51 Dongle programming

microchip

Hi,

I want to use the nRF51 dongle with the Master Control Panel. I found in the nRF51 Dongle User Guide that the Dongle will run with the Master Emulator firmware, but not how to programm the dongle.

Is there a manual available?

Parents
  • 0

    Hi, the firmware is located in the Master control panel installation directory under firmware. You should choose the 0.10.0 version for PCA10000. Next step is to program the firmware via nRFgo studio by following these steps:

    1. Open the latest nRFgo studio and then choose the master dongle you want to use in the device manager menu.
    2. Click erase all button
    3. Under "program application" tab, browse the location of the MCP firmware. Then click on program.
Reply
  • 0

    Hi, the firmware is located in the Master control panel installation directory under firmware. You should choose the 0.10.0 version for PCA10000. Next step is to program the firmware via nRFgo studio by following these steps:

    1. Open the latest nRFgo studio and then choose the master dongle you want to use in the device manager menu.
    2. Click erase all button
    3. Under "program application" tab, browse the location of the MCP firmware. Then click on program.
Children
Related