nRF51422 issues with 2nd harmonic FCC testing

[Danny]

Hi,

I'm using the attached circuit and we recently took our product to FCC testing and failed the 2nd harmonic because we were transmitting too much power.

I'd like to tune the pi network based on your white paper nWP-017 and I think I have an understanding of how to do so.

My question is, once I tune the pi filter will C26 throw everything out of balance? What is C26 used for?

Any additional advice or suggestions would be greatly appreciated!

We're at an EMC testing facility and we have access to a network analyzer. We measured the impedance of the antenna and it's feed line and we're at 48 ohms for the real part and we're at -10 for the imaginary part. It seems that the antenna is pretty well matched to 50 ohms as I would expect.

Thanks, Danny

[Asbjørn]

To a certain extend we don't have any issues with customers doing tuning like this and following the "if it works and passes, it works and passes"-philosophy.

To give you some better understand of the components. There's no pi-filter for the antenna in the schematic you have attached originally. All the components from C28 to C58 are there to handle the output of the radio and make sure the output is filtered and converted into a 50 Ohm single ended output. So at C58/L1 is where you have the 50 Ohm point. So the components you have changed is not intended to be used for tuning the antenna, but you can tune what is delivered to the antenna. If I saw this schematic without you telling me that you have passed I would never have recommended doing what you have done, as I would expect you to run into issues with other harmonics or spurious due to the 0 Ohm resistors you have replaced some of the components with. There's nothing wrong with the operation of the radio, it would just be a regulatory issue, but since you have passed everything would be ok from Nordics point of view too.

Just to be on the safe side here, what you have done works for your application. We still recommend customers to follow Nordics reference layout and schematic closely.

[Danny]

Any feedback will be greatly appreciated.