NRF Connect shows no device available.
usb interface MCU which embeds a j link is not detected by windows.
LED5 is blinking.
I have an external jlink to try to recover, how to procced?
NRF Connect shows no device available.
usb interface MCU which embeds a j link is not detected by windows.
LED5 is blinking.
I have an external jlink to try to recover, how to procced?
Hello,
I have the same problem. I see "No devices available" in Programmer.
LED 5 blinks fast. LED 3 blinks slow (about once per second)
Setup:
- Windows PC, nRF Connect v3.7.1 - Programmer v1.4.11
- The board is older, i have it from a colleague until my order arrives
Board info: PCA10090, 0.9.0, 2019.20, 960076819
Below is a pic with the board. Maybe some jumpers are not set ok?
Hello, and thanks for notifying us about this issue.
As this ticket, and my answer, are from May 2019 there have been several improvements/changes. Can you please register a new ticket with your issue?
Thank you!
Kind regards,
Øyvind
Hello, and thanks for notifying us about this issue.
As this ticket, and my answer, are from May 2019 there have been several improvements/changes. Can you please register a new ticket with your issue?
Thank you!
Kind regards,
Øyvind