NRF Connect shows no device available.
usb interface MCU which embeds a j link is not detected by windows.
LED5 is blinking.
I have an external jlink to try to recover, how to procced?
NRF Connect shows no device available.
usb interface MCU which embeds a j link is not detected by windows.
LED5 is blinking.
I have an external jlink to try to recover, how to procced?
Hello,
This is an ongoing case with AVNET FAE (#228949), please refer to this case.
Edit: Please disregard message above, as this is the only issue we have seen so far on nRF9160. Below is the last answer to FAE involved in the mentioned case above.
We need more details about this case. There have not been any issues in regards to LED5 blinking with the nRF9160 DK. Can you please provide links to the similar cases found on DevZone?
Thanks!
Thank you!
Kind regards,
Øyvind
Hello,
I have the same problem. I see "No devices available" in Programmer.
LED 5 blinks fast. LED 3 blinks slow (about once per second)
Setup:
- Windows PC, nRF Connect v3.7.1 - Programmer v1.4.11
- The board is older, i have it from a colleague until my order arrives
Board info: PCA10090, 0.9.0, 2019.20, 960076819
Below is a pic with the board. Maybe some jumpers are not set ok?
Hello, and thanks for notifying us about this issue.
As this ticket, and my answer, are from May 2019 there have been several improvements/changes. Can you please register a new ticket with your issue?
Thank you!
Kind regards,
Øyvind