How to re-test the ble_zigbee_dynamic_door_lock_nus example?

[Hsu]

Hi Sir,

SDK: nRF5SDKforThreadandZigbeev300d310e71

Example1: \examples\multiprotocol\ble_zigbee\ble_zigbee_dynamic_door_lock_nus

Example2: \examples\zigbee\experimental\cli\cli_agent_router

IC: nRF52840

ENV: nRF52840-DK x 2

I tried to follow this example to test and I can get a response w/ "zdo match_desc ffff ffff 0104 1 0101 0".

And the following step can on/off the BSP_LED_3 for door lock/unlock when the first test operation. 

But when I power off the EVB both and power on to test again, I cannot get the response w/ the command "zdo match_desc ffff ffff 0104 1 0101 0" in 2nd-time operation.

Now I tried to eraseall and re-program the flash, and I can get the response w/ command "zdo match_desc ffff ffff 0104 1 0101 0".

But it doesn't make sense to do re-test w/ erase flash and program every time.

How do I re-test this example without an erase flash and program image?

Thank you.

BRs, Han

[AndreasF]

Hi.

Do you have any sniffer logs?

Best regards,

Andreas

[Hsu]

Hi Andreas

I don't keep the log for the previous test.

I erase / program and test again, the log as below.

I power off/on for both device before 2nd run test.

-----------
> bdb role zc
Coordinator set
Done
>
> bdb start
Started coordinator
Done
>
>
> zdo match_desc ffff ffff 0104 1 0101 1 0
Sending broadcast request.
> src_addr=A30 ep=8

> zdo ieee_addr 0xa30
> 0b010e15c2aa80e6
Done

> zcl cmd 0b010e15c2aa80e6 8 010 1 1 -p 0104 00
> Done

> zcl cmd 0b010e15c2aa80e6 8 0101 -p 0104 00 1
Done

> Done
>
>
> bdb role zc
Coordinator set
Done
>
> bdb start
Started coordinator
Done
>
>
> zdo match_desc ffff ffff 0104 1 0101 1 0
Sending broadcast request.
>
Done

----------

[Hsu]

Update the steps.

1. program below examples w/o modification.

EVK1: \examples\multiprotocol\ble_zigbee\ble_zigbee_dynamic_door_lock_nus

EVK2: \examples\zigbee\experimental\cli\cli_agent_router

2. run the door lock procedure -> result success. 

3. power off and power on for both devices.

4. run again the door lock procedure -> result failed.

Thank you.

BRs, Han

[AndreasF]

Hi Han.

You need to provide me with a Wireshark sniffer log so that I can understand the issue better, please read here how to setup the packet sniffer.

Best regards,

Andreas

[AndreasF]

Hi again Han.

I have looked a bit more into the issue and found the solution.

You have to set the ERASE_PERSISTENT_CONFIG to false in main.c of the cli_agent_router example.

#define ERASE_PERSISTENT_CONFIG             ZB_FALSE               

Because this was set to true it creates a new network each time you reset the device.

Best regards,

Andreas

[Hsu]

Hi Andreas,

Thanks, it works.

Best regards,

Han