This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

flash programming PCA10000 using Master Control Panel

Hi, whenever i try to program the PCA10000( USB dongle) using MASTER CONTROL PANEL(3.4.0) i'm getting log messages like as below,

"........... Successful flash! Enabling read back protection for ALL regions Resetting, SysReset "

After returning to main window i'm getting log message's like

"[16:50:41.4] Loading... [16:50:48.5] No response from master emulator. [16:50:48.9] SERVER: Server has started"

so, what actually no response from master means? i cannot able to start the start discovery whenever i click on it, it says no command complete event received... i am totally new to this, please help me to overcome this.

Regards, Balaji

Parents
  • Have you tried replugging the dongle and restarting Master Control Panel after flashing? It seems that this is at least sometimes required to make things work.

  • yes, i have tried replugging the dongle and restarting the Master Control Panel (several times), still the same issue is there. I also did firmware update when i connected the dongle for the first time.

Reply
  • yes, i have tried replugging the dongle and restarting the Master Control Panel (several times), still the same issue is there. I also did firmware update when i connected the dongle for the first time.

Children
No Data