I2C clock frequency problem

[Manjunath K S]

Hi,

I am using NRF52832 development board , to which i have interfaced LIS3DSH accelerometer sensor(3.3V i2c)

when i  configure it for 1600 sampling rate and all the axis enabled , i am not able to get any data .

could anyone help with this problem.

also the I2c clock frequency, as shown in below image, while i am capturing data when i observe in oscilloscope or logic analyzer , clock frequency is showing 200 all the setting is for 400KHz.

what could be the problem for this or is there any other way i need to follow to set the clock to 400KHz.

help me ASAP...

Thank you

[haakonsh]

"also the I2c clock frequency, as shown in below image, while i am capturing data when i observe in oscilloscope or logic analyzer , clock frequency is showing 200 all the setting is for 400KHz."
That's unlikely, I think you're measuring the clock frequency incorrectly.


Why have you enabled pulldowns on your IO pins?

[Manjunath K S]

actually that's not the part of code , sorry excluding that is the actual code

[haakonsh]

Do you have a scope of the communication?

[Manjunath K S]

scope in the sense, where i am using it right.

i am using it to aquire acceleration data

[haakonsh]

We need more information on your issue, a scope will help us greatly.