This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Flashing nRF51822 with U-link2

I am using keil compiler. The nRF51822 stack succesfuly compiled and also i am created the hex.I don't have j-link programmer but i will try to download using Ulink2 can u help me

here i attached the circuit for your referenceProgrammer.png

Parents

0 ARUN over 9 years ago

Sure. I am using WT51822 module (3rd party module).It's purchased from wavetek-Hong Kong. In my hand Ulink2 programmer, its how helpful to programming this module?.Its suitable for this? The programmer details for you http://www.keil.com/ulink2/
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 ARUN over 9 years ago

Sure. I am using WT51822 module (3rd party module).It's purchased from wavetek-Hong Kong. In my hand Ulink2 programmer, its how helpful to programming this module?.Its suitable for this? The programmer details for you http://www.keil.com/ulink2/
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Annim over 9 years ago in reply to ARUN

Hi, i would like to request you to go and find the list of supported devices for ULink2 here... , and also, please find this post here... and also here , go through the answers too, Thus, get segger jlink lite and get started. Or if you able to use ulink2 with nrf51822, then surely post one short article about the same . I am using segger jlink lite for this. Good luck. Accept the answer which ever you find appropriate.
Cancel
Vote Up 0 Vote Down

Cancel