This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nRF 52840 PCB design

I am designing a pcb just the nRF 52840 MCU. The design of the PCB is based on the reference design from Nordic. 
When ordering the PCB I came across a problem that the vias under the MCU are too small and too close together to be able to order the PCB for a
normal price.
I have been informed that the technique with which this can be done properly is a laser technique that companies like Eurocircuits.com do not have.
This means that I cannot realize the design before this problem can be solved. The chip is constructed in such a way that the vias must be so small.
Is there an alternative where I can order the PCB for a normal price or are there cheaper design options that reduce the costs?
Parents
  • Have you considered using a module?

    I was going to suggest this too, but this depends on two things:

    1) Will a module physically fit the desired PCB design (I know some people want to build really tiny boards)

    2) Will the added cost be a problem

    You can buy the nRF52840 IC in large quantities for about $4 each, but for the Rigado BMD-340 it's more like $8. However with the BMD-340 you also get a built-in BLE antenna and an integrated 32MHz crystal. Whether that balances things out or not depends on the application design, I guess.

    My friend and I elected to go with the Rigado module for our project primarily to avoid (we hope) potential problems with the nRF52840 footprint. We were able to do a large order to help reduce the per-unit cost. It was still annoying to route everything, but not as bad as it might have been with the IC itself.

    -Bill

Reply
  • Have you considered using a module?

    I was going to suggest this too, but this depends on two things:

    1) Will a module physically fit the desired PCB design (I know some people want to build really tiny boards)

    2) Will the added cost be a problem

    You can buy the nRF52840 IC in large quantities for about $4 each, but for the Rigado BMD-340 it's more like $8. However with the BMD-340 you also get a built-in BLE antenna and an integrated 32MHz crystal. Whether that balances things out or not depends on the application design, I guess.

    My friend and I elected to go with the Rigado module for our project primarily to avoid (we hope) potential problems with the nRF52840 footprint. We were able to do a large order to help reduce the per-unit cost. It was still annoying to route everything, but not as bad as it might have been with the IC itself.

    -Bill

Children
Related