nRF9160 > Count pulse on GPIO

[Oleh]

Dear Team,

what is the way to do it in Zephyr? 

I have a signal up-to 10kHz, what is the best way to keep the counter in the background?

Thank you and best

Oleh

[Didrik Rokhaug]

Hi.

You can use Zephyr's GPIO driver to configure interrupts. 

Have a look at the documentation here.

Best regards,

Didrik

[Oleh]

Hi Didrik,

thank you, I'm new to Zephyr so trying to map my nrf knowledge to zephyr

To complement and test the counter on gpio, I thought to put the second DevKit board into generation mode. Could you please point on the right track with how can the generation on-off be done in background on Zephyr?

thanks & best

Oleh

[Oleh]

Hello and thank you!

short question: what is the best way to suspend / resume the ppi in this sample? 

and how to safely reset counters?

[Didrik Rokhaug]

Hi, and sorry for the late reply.

For resetting counters, I would use the nrfx_timer_clear function.

For suspending/resuming DPPI, you would have to either stop the events from being generated, not publish the events, or subscribe to them (or all at once).

[Oleh]

Hi and thank you for your input.

I managed to update and make the code working! great! thank you!

Regarding the Suspend/Resume, just for info: I need it in order to save power, as the sensor is external and connected to a stepup convertor, so when not in use -- I would like to power it off. Thus also disable DPPI. 

Best regards

Oleh

[Didrik Rokhaug]

After digging some more through the nrfx drivers, I also found the nrfx_dppi_channel_disable (and _enable) functions, which should let you stop and start the specific DPPI channel.

[Oleh]

Hi Didrik, 

you just rock! thank you for all your support!

Best

Oleh