Thingy:91

[Hoang]

Dear, 

I received THINGY:91 from NordicSemi. I use 10pins cable to connect to nRF9160 DK to program for THINGY:91. 

and, I am using ncs_v1.0.0

I am trying to run asset_tracker application, 

and I am confusing about: 

1. which board should I select? I tried to use    ncs_v1.0.0/zephyr/boards/arm/nrf9160_pca10090

but after programming, the LED on THINGY:91 changed to RED color, and I couldnt connect it from nrfcloud 

I couldn't find pca20035 on ncs_v1.0.0. Do I need to use another version of ncs ?

2. How can I debug the output from THINGY:91

The terminal still shows the output from nRF9160 DK, nothing from THINGY:91

Thanks, 

Mvh

Hoang Nguyen

[Hoang]

Dear Bjørn Kvaale

I found nrf9160_pca20035 then I tried to program asset_tracker to THINGY:91, pressed the button (long press) then connected to nrfcloud and put the THINGY:91 outside. 

"Waiting for GPS Data...."

How to activate GPS? Do I need to use the external GPS antenna? 

Thanks 

Mvh

Hoang Nguyen

[Hoang]

Hi MJD093 Can you help?

[Hoang]

Thanks so much for your info, MJD093, Regards

[Hoang]

Hi Bjørn Kvaale, MJD093

I found the reason. It is my fault: 

#ifdef CONFIG_BOARD_NRF9160_PCA10090NS
#define AT_MAGPIO      "AT\%XMAGPIO=1,0,0,1,1,1574,1577"
#endif

with THINGY:91, must remove: AT\%XMAGPIO=1,0,0,1,1,1574,1577

Then, GPS will work. 

Thanks so much,

Mvh

Hoang Nguyen

[Bjørn Kvaale]

It seems this issue has been resolved by removing this AT command: 

AT\%XMAGPIO=1,0,0,1,1,1574,1577

[MJD093]

Bjorn Kadding or removing? From the code snippet that was linked in the verified answer, wouldn’t that not use the MAGPIO settings if the board was anything other than PCA10090?

[Hoang]

Hi MJD093: removed it when i used thingy:91,  the MAGPIO settings just define for PCA10090, I dont know how about other boards! Bjørn Kvaale