This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

JLinkARM DLL reported an error.

We have a board that has become unresponsive to programming. It worked well to program about 4 times and then is no longer responding to the J-Link device. The application is still running and sending data on the UART and SPI to a peripheral. I have attached the log from the following command: nrfjprog -e -f NRF91 --log

That command responds with:

ERROR: JLinkARM DLL reported an error. Try again. If error condition
ERROR: persists, run the same command again with argument --log, contact Nordic
ERROR: Semiconductor and provide the generated log.log file to them.