zigbee

[jagadeesh surneni]

hi,

i want to implement zigbee protocol. our requirement is 50 nodes with mesh topology.please suggest us the example code.

Regards,

jagadeesh

[awneil]

Have you looked?

[jagadeesh surneni]

hi,

i have taken three boards. in one board i have dumped light coordinator code. and other two boards i have dumped light switch code.i am using internal clock.there is no network connection.

// <e> NRFX_CLOCK_ENABLED - nrfx_clock - CLOCK peripheral driver
//==========================================================
#ifndef NRFX_CLOCK_ENABLED
#define NRFX_CLOCK_ENABLED 1
#endif
// <o> NRFX_CLOCK_CONFIG_LF_SRC - LF Clock Source

// <0=> RC
// <1=> XTAL
// <2=> Synth
// <131073=> External Low Swing
// <196609=> External Full Swing

#ifndef NRFX_CLOCK_CONFIG_LF_SRC
#define NRFX_CLOCK_CONFIG_LF_SRC 0
#endif

// <o> NRFX_CLOCK_CONFIG_IRQ_PRIORITY - Interrupt priority

#ifndef NRFX_CLOCK_CONFIG_IRQ_PRIORITY
#define NRFX_CLOCK_CONFIG_IRQ_PRIORITY 6
#endif

/***********************************/

NRF_LOG_INFO("Joined network successfully");
bsp_board_led_on(ZIGBEE_NETWORK_STATE_LED);
nrf_gpio_pin_set(PAIR_LED);

/* Check the light device address */
if (m_device_ctx.bulb_params.short_addr == 0xFFFF)
{
zb_err_code = ZB_SCHEDULE_ALARM(find_light_bulb, param, MATCH_DESC_REQ_START_DELAY);
ZB_ERROR_CHECK(zb_err_code);
zb_err_code = ZB_SCHEDULE_ALARM(find_light_bulb_timeout, 0, MATCH_DESC_REQ_TIMEOUT);
ZB_ERROR_CHECK(zb_err_code);
param = 0; // Do not free buffer - it will be reused by find_light_bulb callback
}
}
else
{
NRF_LOG_ERROR("Failed to join network. Status: %d", status);
bsp_board_led_off(ZIGBEE_NETWORK_STATE_LED);
nrf_gpio_pin_clear(PAIR_LED);
zb_err_code = ZB_SCHEDULE_ALARM(light_switch_leave_and_join, 0, ZB_TIME_ONE_SECOND);
ZB_ERROR_CHECK(zb_err_code);

/****************************************/

Regards,

jagadeesh

[awneil]

jagadeesh surneni said:

three boards

What boards, exactly?

Are you getting any log messages?

What debugging have you done?