USB CDC ACM example is not working in 52840

[Deepa Gopinath]

Hi Nordic, 

While testing USB CDC example with nRF 15.3.0 in PDK board, I see USB is not recognized. I have gone through the same issue posted in Forum. Is it the issue with board? I am using v0.9.0 PDK board. Need help in resolving this.

Thanks,

Deepa Gopinath

[Sigurd]

Hi,

Engineering A version of the nRF52840 is not longer supported, starting from SDK 15. See this compatibility matrix. Engineering A is used on the 0.9.x versions of the nrf52840 (P)DK (PCA10056). See this link. The "preview" DK is no longer recommended for development. Please order a new nRF52840-DK. New versions of the DK uses the production silicon(IC revision 1 and 2).

[Deepa Gopinath]

Thank you for the info.

Regards,

Deepa Gopinath

[Deepa Gopinath]

Hi, I've checked with the hardware revision and the development kit I am using has nRF52840 QIAACO which is revision 1. So when I run CDC example, it should work on my kit right? But When I connect to my PC, it is not getting detected as  nRF52 USB CDC DEMO. And is there any workaround to make it work with old hardware revisions (On PDK board)?

[Sigurd]

Hi,

Deepa Gopinath said:

the development kit I am using has nRF52840 QIAACO which is revision 1. So when I run CDC example, it should work on my kit right?

Yes.

Deepa Gopinath said:

But When I connect to my PC, it is not getting detected as  nRF52 USB CDC DEMO

 Are you using Windows 7? If yes, see step 4 at this page on how to install the CDC drivers.

Deepa Gopinath said:

And is there any workaround to make it work with old hardware revisions (On PDK board)?

 No.