I have been using Power Profiler Kit nRF6707 for awhile without problem.I made a mistake by downloading firmware when the PPK is attached to nRF52 DK, the software on the PPK is wiped out. However, I simply just needed to drag ppk_v1_1_0.hex to JLINK Drive to re-flash PPK.
Now I made accidentally program the PPK again but this method does not work. The LED on PPK is always off. I have program ppk_110.hex file from folder name nRF6707 Power Profiler Kit - Software files 1_1_0. but LED on PPK is always off. Also I want to know that what LED2 indicate ?
Thanks in Advance
Remove the DK (so that you are sure that you are programming the PPK), and flash that firmware by running flash_ppk.py. You may need to power cycle the PPK for it to start up.
Please also see this post.
Also I want to know that what LED2 indicate ?
LED2 indicates the power on the PPK. The power supply is selected using the power select switch (SW4). When the DK is selected as the power supply, the DK supplies the PPK circuitry, and the LED2 is lit.
Thanks for quick reply. I didn't find any information for LED 1 in PPK user v2.4. According to my understanding LED 1 is On When I clicked start on nrfConnect Desktop Application and LED 2 as per your answer.
The Problem is resolved now.
Great to hear the problem is resolved.
The LED1 works as you observed.
Please verify the answer to benefit other users. Thanks.