Greetings...
Provisioning w/ Android tool only works when board is connected to debugger.
Provisioning failed to even find the devices when scanning after disconnected from SES.
Any tricks? Thanks!
M
Greetings...
Provisioning w/ Android tool only works when board is connected to debugger.
Provisioning failed to even find the devices when scanning after disconnected from SES.
Any tricks? Thanks!
M
Hi,
Can you give me more details? What doesn't work when you are not connected tot the debugger? Are you using a custom board? Which example are you testing with?
Provisioning failed to even find the devices when scanning after disconnected from SES.
What do you mean by this?
After you downloaded the firmware to your board, did you provision the the board through nRF Mesh app?
Ok, could you clarify what you mean by this:
"Provisioning w/ Android tool only works when board is connected to debugger."
Okay, if you leave board connected w/ SES debugger, and don't power cycle after downloading, then run the firmware inside the debugger, then nRF Mesh app will find the board properly and thus you can provision the board fine.
Hence the statement:
Provisioning w/ Android tool only works when board is connected to debugger.
Hope this clears...
Thanx!
M.
Which exact buttons are you pressing to download your code? Have you tried going clicking on "Target" - > "Download..."? Then power cycling the board.
Also try erasing everything before doing this.
Yes, those are the steps I followed...
It seems weird that it don't work on the latest release but on the earlier releases. Did you do the exact same thing with an earlier version, without any modifications, and it worked?
It seems weird that it don't work on the latest release but on the earlier releases. Did you do the exact same thing with an earlier version, without any modifications, and it worked?
Yes, this is the case! Were you able to verify it, Mttrinh?
Thanks.
M.