Zigbee Cli Agent Router example hangs after bdb start command

[[email protected]]

I am using nrf52840 dk for zigbee project with two xbee modules. One xbee is configured as coordinator and other as end device and nrf board is supposed to act as router. After setting channel and pan id from cli when I enter bdb start , command prompt just hangs .

[Edvin]

Have you done any changes in the SDK? Remember that if you change something in one project, it may affect other examples as well, if you change one of the common files.

If you are not sure whether anything is changed, please try an unmodified version of the SDK. If the issue still persist:

What SDK version do you use? Does the issue happen if there are no XBee devices turned on nearby as well, or only if they are present?

Can you do a sniffer trace to see if the nRF transmit any packets (even though the CLI stops resonding)?

Best regards,

Edvin

[[email protected]]

I have not done any changes to SDK and I am using "nRF5_SDK_for_Thread_and_Zigbee_v4.0.0_dc7186b" this one. Currently I am doing sniffer trace . I will let you know about result shortly. Thanks for reply.

[[email protected]]

When I connect nrf52840 dk from nrf usb port to pc after flashing sniffer firmware , Windows 10 shows usb device is not recognized . 

[Edvin]

Hello,

Have you tried letting it be connected for a while? Perhaps windows will find some drivers eventually. Also, have you followed the instructions in the "Installing Wireshark and extcap plugin" section from the link in the previous reply? Does the device show up in Wireshark?

[[email protected]]

No , the device is not listed in wireshark even after refreshing interfaces.