NRF9160 AWS FOTA over HTTPS

[odwraca]

I have been reviewing this merge: https://github.com/NordicPlayground/fw-nrfconnect-nrf/pull/1982 and it appears that there is capability in the fota example to enable https/tls download for the aws fota example. It appears that DOWNLOAD_CLIENT_TLS needs to be set in the config, but when I set it in the KConfig it failed to build. I am using CLI, not Segger. 

My guess is that I am setting this in the wrong place but my attempt at backtracking this is failing a bit. Was hoping that someone could chime in with where I need to enable the TLS. 

• I am planning on using S3 as the bin source, so the sample cert that was setup should suffice (from what I can tell).
• I have successfully used the AWS FOTA example over http, but https is required for the project. 

Apologies for the noob questions, just trying to sort this out. 

[Simon]

I am sorry for the delay, The staffing is reduced during easter due to holidays and I will be gone this week, but I will be back Tuesday next week and will look at your ticket then.

Best regards,

Simon

[odwraca]

Thanks Simon, check my latest comment for current status. I have not had the opportunity to troubleshoot much further, but if I do I will post an update.

[Simon]

Before investigating this further, have you tested this out with the newest version of NCS master? The changes from https://github.com/NordicPlayground/fw-nrfconnect-nrf/pull/1982 are merged into the master.

If you're not able to make it work with master or if you have to stick with e.g. NCS v1.2.0, I'll take a closer look at your problem.

This case may be useful: https://devzone.nordicsemi.com/f/nordic-q-a/58664/nrf9160-fota-over-https

Best regards,

Simon