Power consumption using FreeRTOS

[shai.c]

Hi,

I'm using an application with FreeRTOS, nRF52833, SDK 16.

When I'm trying to get it into low power (sleep mode) the system still consumes ~4mA

In vPortSuppressTicksAndSleep (port_cmsis_systick.c file) I forced to use WFE instead sd_app_evt_wait

#if 0  
    #ifdef SOFTDEVICE_PRESENT  
    if (nrf_sdh_is_enabled())  
    {  
        uint32_t err_code = sd_app_evt_wait();  
        APP_ERROR_CHECK(err_code);  
    }  
    else  
#endif  
    #endif  
    {  
        /* No SD -  we would just block interrupts globally. 
        * BASEPRI cannot be used for that because it would prevent WFE from wake up. 
        */  
        do{  
            __WFE();  
        } while (0 == (NVIC->ISPR[0] | NVIC->ISPR[1]));  
    }  

After changing it the power consumption was reduced by ~3.5mA

What is the proper way to fix this problem?

[Susheel Nuguru]

I cannot think of anything.very specific.

Please check if you are hit by ERRATA  78 or 87 as mentioned here

[shai.c]

Hi,

I checked ERRATA 87 - CPU: Unexpected wake from System ON Idle when using FPU, according to the Workaround the following code need to be added before calling WFE 

#if (__FPU_USED == 1)
 _set_FPSCR(_get_FPSCR() & ~(0x0000009F)); 
 (void) __get_FPSCR();
 NVIC_ClearPendingIRQ(FPU_IRQn);
#endif

Does this code need to be added also before calling sd_app_evt_wait? ( I'm using SOFTDEVICE)

however, I tried to add this before calling sd_app_evt_wait but it didn't help

Any other suggestions?

[shai.c]

Thanks for your answer, but disabling and then enabling the MWU didn't change the power consumption 

I will be glad if you will test it

Thanks

[Susheel Nuguru]

I am sorry for coming back late. I am struggling a bit trying to make the SDK16 SES freertos_hrs project run on pca10100.

• Just changing the preprocessing defines
• replacing startupfiles to match nrf52833
• and fixing linker values seems not enough.

Can I please get your project that runs on pca10100 on sdk16, so that I flash and see the results in the power profiler. 

[shai.c]

Hi,

Attached hrs freertos_hrs project

4810.ble_app_hrs_freertos.zip

[Susheel Nuguru]

Hi Shai,

Verified your descritption. You were right. Something is causing the softdevice wakeup too early. Please replace the sd_app_evt_wait with the below code in port_cmsis_systick.c. I have verified my suggestion to improve the power. We will investigate further if this behaviour is same with the coming SD versions to see if we need to fix something.

        if ( xModifiableIdleTime > 0 )
        {
#ifdef SOFTDEVICE_PRESENT
            if (nrf_sdh_is_enabled())
            {
                do{
                  uint32_t err_code = sd_app_evt_wait();
                  APP_ERROR_CHECK(err_code);
                } while (0 == (NVIC->ISPR[0] | NVIC->ISPR[1]));
            }

[shai.c]

Hi Susheel,

Thanks for your answer, I tested it and the behavior looks like using WFE